EverSewn Sparrow X - Iron-On Interfacing

31
Embroidery Preparation
v
Iron-on interfacing
Iron-on interfacings are available in a variety of weights. Iron-on interfacings should be selected
to suit the material being used. Use an iron-on interfacing which is easily removable from the
material.
Fuse the iron-on interfacing to the wrong side of material and press.
Application:
- Please use an appropriate stabilizer and cut it in a bigger shape than your embroidery
pattern. Then place it onto the design for support.
Paper-backed adhesive stabilizer
- Place stabilizer in hoop with paper side up.
- Use a pointed tool (e.g. scissors) to score the paper.
- Remove the paper to reveal the sticky surface.
- Position the fabric over the sticky surface and smooth into place.
Application:
- Intended for delicate materials such as jersey or silk etc.
- For hard-to-hoop parts and materials.
Note
Make sure that the adhesive residue on needle, stitch plate and hook area are totally removed.
Water soluble stabilizer
Water soluble stabilizer looks like plastic wrap. When you nish emboridery design, simply
submerse project in warm water to dissolve stabilizer. Water soluble stabilizer helps keep the
stitches from disappearing in high-pile fabrics (such as towels of uffy cotton).
- Place the water-soluble stabilizer on top of the fabric.
- Place all layers together into the embroidery hoop.
- Use adhesive spray to x stabilizer if necessary.
- For pile fabrics, an additional stabilizer on the wrong side is suggested for reinforcement.
- After nishing the sewing, dissolve it and lay the project until dry.
Application:
- Available for towel, velvet, bouclé and etc.
- Available for ne, sheer material such as organdy, bastiste and etc.
- Available for lace embroidery.