1
2
Make the embroidery foot lever upwards.
Tilt the embroidery foot and insert it from left
to right so that the notch ts into the presser
foot bar, and then push the embroidery foot
upwards until it is aligned with the screw.
Presser foot bar
The embroidery foot lever will be against the
top of the Needle clamp screw, then tighten
the screw by using the screwdriver.
Screw
Hold the sewing table horizontally, then pull
toward the left to remove it from the machine.
Slide the embroidery unit onto the machine
arm. Push lightly until the unit clicks into
place.
n
Attention
Once embroidery unit is installed, foot
control cannot be operated.
Note
Please check and make sure the presser
foot is raised and remove embroidery hoop
rst before attaching embroidery unit onto
the machine.
To Next Page
