Eversys e'4m - Page 76

8 Troubleshooting
76/ 106 e’line User Manual | © Eversys AG
W-037 The milk system was cleaned
without detergent.
Please use "Everclean"!
None or not sufficient detergent detected for a
proper cleaning of the milk system.
“7.3.1” on page 64
W-038 Coffee boiler temperature
sensor failure front.
Please check the temperature
sensor and cable.
Contact service organization. -
W-040 Milk heater temperature sen-
sor failure front.
Please check the temperature
sensor and cable.
Contact service organization. -
W-048
During the weekend all milk
products are locked!
Occurs only if you have turned on "Cleaning
Weekend Mode" ("Clean/Standby" menu)
“11.4.5” on
page 102
W-050 Fan Front doesn't run.
Check if the fan is plugged in
correctly.
Contact service organization. -
W-054 Milk pump doesn't run. Contact service organization. -
W-056 Milk input temperature sensor
failure.
Please check the temperature
sensor and cable.
Contact service organization. -
W-058 Milk tank temperature front
too high.
Please fill the milk tank with
cold milk.
The temperature of the milk in the fridge is too
high.
Use and refill only cooled milk.
-
W-060 Milk module not connected. Contact service organization. -
W-065
Please schedule next service
with your service technician.
In the next few weeks a service will be necessary.
It's good to plan the next service early enough
(no last minute action).
Please call your service technician.
“7.1.2” on page 61
W-066
Please schedule water filter
change with your service tech-
nician.
In the next few weeks a water filter change will
be necessary.
It's good to plan the next water filter change
early enough (no last minute action).
Please call your service technician.
“7.1.2” on page 61
W-068 The front grinder is blocked.
Close the front bean hopper.
Press "Continue" to start
automatic grinder unblocking.
Contact service organization. -
W-075
The extraction time is too
high.
Please press "Continue" to
start a rinse.
The extraction time is more than 15 s too long
three times running.
To check if the machine has a problem, a rinse
will be performed after pressing "Continue".
If the warning doesn't disappear after the rinse,
login with manager password:
=> Consult the rinse history for more information
=> Please call your service technician.
“11.4.1” on
page 98
# Info message Explanation / Corrective action Refer to