EVGA X299 Micro - Page 129

EVGA X299 Micro (131-SX-E295)
- 129 -
0F Microcode not loaded
10 PEI Core is started
11-14 Pre-memory CPU initialization is started
15-18 Pre-memory North Bridge initialization is started
19-1C Pre-memory South Bridge initialization is started
1D-2A OEM pre-memory initialization codes
2B Memory initialization. Serial Presence Detect (SPD) data reading
2C Memory initialization. Memory presence detection
2D Memory initialization. Programming memory timing information
2E Memory initialization. Configuring memory
2F Memory initialization (other).
30 Reserved for ASL (see ASL Status Codes section below)
31 Memory Installed
32 CPU post-memory initialization is started
33 CPU post-memory initialization. Cache initialization
34 CPU post-memory initialization. Application Processor(s) (AP) initialization
35 CPU post-memory initialization. Boot Strap Processor (BSP) selection
36 CPU post-memory initialization. System Management Mode (SMM) initialization
37-3A Post-Memory North Bridge initialization is started
3B-3E Post-Memory South Bridge initialization is started
3F-4E OEM post memory initialization codes
4F DXE IPL is started
50 Memory initialization error. Invalid memory type or incompatible memory speed
51 Memory initialization error. SPD reading has failed
52 Memory initialization error. Invalid memory size or memory modules do not match.
53 Memory initialization error. No usable memory detected
54 Unspecified memory initialization error.
55 Memory not installed
56 Invalid CPU type or Speed
57 CPU mismatch
58 CPU self-test failed or possible CPU cache error
59 CPU micro-code is not found or micro-code update is failed
5A Internal CPU error