36
Using Your Evinrude E-TEC Outboard
TILTING AND TRIM
MANUAL TILT MODELS
IMPORTANT: Use the tilt grip to tilt your out-
board. Do not use the tiller handle as a lever.
Tilt UP
Move the tilt/run lever to TILT position.
Grasp the tilt grip on engine cover and tilt out-
board to the full tilt position.
The tilt support bracket will automatically en-
gage.
Tilt DOWN
Move tilt/run lever to RUN position.
Grasp the tilt grip on engine cover and raise
outboard slightly. The tilt support will automat-
ically disengage. Slowly lower outboard to its
normal operating (RUN) position.
Operate outboard in normal
operating position with tilt/run lever in the
RUN position.
1. TILT position
007022
1. Tilt grip
007023
1. Tilt support bracket
007025
A WARNING
Leave tilt/run lever in the TILT position
while outboard is tilted. If the tilt/run
lever is moved to the RUN position, the
tilt support bracket can release and the
outboard could drop down unexpectedly.
1. RUN position
007024
To Next Page
Loading...
Need help?
General
