4. Gather Tools
For comfortable installation of the EVIQO Smart EV Charger and depending on the type
of installation - plugged-in or hardwired, you might need:
1) One NEMA 14-50 outlet or supplies to install a hardwired dedicated circuit
2) Tape (optional, will help to attach the Mounting Templates to the wall, if needed)
3) Pencil (optional, will help to mark the holes to drill if you have concrete/brick walls)
4) Stud finder (optional, to properly locate the studs)
5) Level (optional, to properly install the brackets)
6) Drill (optional, if you have concrete/brick walls and use expansion bolts)
7) Adjustable Ratchet Wrench (optional, for proper expansion bolts fixation)
8) Wire stripper (optional, for hardwired installation)
9) Voltmeter or digital multimeter (optional, for measuring AC voltage at the installation
site).
10) Screwdriver (optional, if you need to open the faceplate of the charger)
Note: The above tools are important, ensure to have them all for proper installation.
To Next Page
Loading...