1. Important Safety Instructions
PLEASE KEEP THESE INSTRUCTIONS SAFE
WARNING: This Installation Guide contains important instructions for
your EVIQO Smart EV Charger. Remember to always follow simple
precautions when using electronic products, including the following
guidelines.
CAUTION: Please note that strictly following the information
provided in this manual does not exempt the user from their
responsibility to comply with all relevant codes and safety standards.
This Installation Guide outlines the typical installation and mounting
scenarios. If any situation arises where it is not feasible to carry out
an installation according to the procedures specified in this
document, please reach out to EVIQO TECHNOLOGIES LIMITED
directly. Please note that EVIQO TECHNOLOGIES LIMITED cannot
be held liable for any damages that may arise from custom
installations not specified in this document or failure to comply with
the recommendations provided in this Installation Guide.
1.1 Overall Warnings & Cautions
WARNING: To avoid fire, property damage, injury or death, carefully read and follow the
instructions during installation, operation and maintenance. Install and operate only as
instructed in this Installation Guide.
- DO NOT put fingers into the electric vehicle connector.
- DO NOT use this product if the input power cord or EV cable is frayed,
insulation-broken, or any other signs of damage.
- DO NOT use this product if the enclosure or the EV connector is broken, cracked,
open, or shows any other indication of defect or damage.
- DO NOT remove cover or attempt to open the enclosure - risk of electric shock.
WARNING: When removing the face cover of the device while it's powered on to access
the hard reset button, it's crucial to avoid touching the L1 IN, L2 IN, PE IN, L1 OUT, L2
OUT, PE OUT connectors, ring terminals, ribbon cable terminals linking the front cover to
the main motherboard, or any other internal components besides the hard reset button -
risk of electric shock.
WARNING: This device should be supervised when used around children.
WARNING: This device must be grounded. Failure to ground the charging station can lead
to risk of electrocution or fire.
WARNING: To avoid a risk of fire or electric shock, do not use this device with an
extension cord.
WARNING: The suitability of the use of flexible cord in accordance with CE code, part I,
rule 4-012, is to be determined by the local inspection authority.
WARNING: To reduce the risk of fire, connect only to a dedicated circuit provided with
branch circuit overcurrent protection in accordance with the CSA C22.1–15 Canadian
Electrical Code, Part 1 (Canada) or NOM-001-SEDE Electrical installations (utility)
(Mexico) or ANSI / NFPA 70 National Electrical Code (USA).
To Next Page
Loading...