9. Configuring Your Device
ATTENTION: After mounting the EVIQO Smart EV Charger, it is
crucial to configure it in order to take full advantage of its wide
variety of smart functions.
ATTENTION: Upon powering up, the EV Charger enters a
15-minute configuration mode if not yet configured. Failure to
configure the device within this timeframe will result in IDLE
mode. If you miss the 15-minute configuration window, simply
unpower the device and power it back on. After 20
consecutive skips to configure it, the device will enter a
constant IDLE mode on the 21st power-up. To re-enter
configuration mode, perform a hard reboot (see Question 4 on
page 4 of this Installation Guide). This will clear the device's
configuration.
Note: To download the EVIQO mobile app, please use the QR codes.
EVIQO APP GUIDE: EVIQO YouTube Videos:
To Next Page
Loading...