OPERATOR INSTRUCTIONS
Affinity 30G
Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA
Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com
28
LIGHTING INSTRUCTIONS
Electronic Ignitor Lighting Procedure:
1. Read instructions carefully before lighting.
2. Cooking surface must be in place and secure before
lighting.
3. Hold down the igniter button, then turn the Control
Knob to ‘Lite’. View the fl ame through the viewing
holes in the Grill body to confi rm it is lit. If the burner is
lit, turn the knob to ‘the desired setting to commence
cooking.
4. If ignition does not occur in 5 seconds release igniter,
turn the burner Control Knob off, wait 5 minutes, and
repeat lighting instructions.
If after the repeated attempt the burner does not ignite,
follow the manual lighting procedure below.
Manual Lighting Procedure:
1. To light the burner manually, attach a match to the
match holder supplied and light the match.
2. Feed the lit match through one of the fl ame viewing
holes in the burner skirt above the control panel until it
is close to the burner.
3. Turn the Control Knob to the ‘Lite’ position. View the
fl ame through the opposite viewing hole in the grill
body to confi rm it is lit. If the burner is lit, turn the knob
to the desired setting to commence cooking.
4. Once the burner has been lit, remove the match and
extinguish the match fl ame.
Control Knob
Match Holder
Match
To Next Page
Loading...
