EVOCA Kalea - OUTPUT SETTINGS; BREWING UNIT; ADVANCED MILK PARAMETERS

52 01-2018 5035 01
output sEttiNgs
brEwiNg
uNit
-No coffee: a sensor detects the rotation of
the grinder when it is grinding; if a block
(e.g. foreign bodies) or excessive speed
(grinder empty) occurs, the control blocks
the selections which use the grinder.
-Pregrinding: enables/ disables the coffee
grinder for the next selection. Pregrinding
reduces the preparation time of the next
selection containing ground coffee.
Pregrinding affects the aroma of the next
selection containing ground coffee.
-Allows the position of the brewing unit's
infusion chamber to be set.
Set the infusion chamber’s position to
allow the coffee powder to be arranged
more evenly in the infusion chamber.
faN paramEtErs
Enables/ disables the operation of the ap-
pliance's fans.
stEam suctioN
-ON: the fan is always active.
-OFF: the fan is active whilst the beverage
is being prepared.
The fan stays on until the dispensing is
complete and for the time that has been
set.
ligHtiNg
Allows the appliance's lighting parameters
to be set.
"usE DEcaffEiNatED coffEE” optioN
The "use decaeinated coee” option can
be enabled for selections which use coee
(beans and/or pre-ground).
milk paramEtErs
It allows setting the time required to ll up
the milk circuit before dispensing a milk-
based selection.
By changing the lling time, the quantity of
milk to be taken is indirectly modied.
This value helps compensate for the dis-
tance between the milk tank and the appli-
ance and/or for pockets in the milk circuit.
If the milk tank is very close to the appli-
ance, set the value to 0.
Dispense some milk-based beverages to
check that the entered value is adequate
for obtaining the correct beverage quantity.
It is possible to set the milk level control
(only for the combined side module).