EVOLIGHTS SPARK PRO
Instrukcja obsługi / User Manual
26
3.4. Disclaimer
The information and specifications contained in this User Manual are subject to change
without notice.
Evolights assumes no responsibility or liability for any errors or omissions and reserves the
right to revise or to create this manual at any time.
3.5. Safety notes
Please read the following Safety Notes carefully before working with the product. The
notes include important safety information about installation, usage, and mainte-
nance.
3.5.1. Personal safety
• Always connect the product to a grounded circuit to avoid the risk of electrocution.
• During heating up and operation, the housing will be scalding hot. Do not touch.
• The product is very hot during operation and it remains hot for a long time after
operation has stopped. Do not touch the product’s nozzle.
• Keep a minimum distance of 6.6 ft. (2 m) from the machine to the nearest human or
flammable material. The output spark from the nozzle must be in the air but not
reaching any object. And mind the falling residue after the spark.
• Make sure that children, unauthorised people and animals do not obtain access to the
machine.
• The operation noise is lower than 80 dB without harm to ear. No need to wear ear
protection when close to the working machine.
• Eye protection is always required when operate the machine closely.
3.5.2. Mounting and rigging
• When using outdoors, for best effects, please place it away from wet ground.
• For safety reasons, we do not recommend mounting the product in any capacity.
Operate the product while it is on the ground only.
• The product is for indoor use! To prevent risk of fire or shock, do not expose the product
to rain or moisture. Optional waterproof case is available for operating in rain.
• CAUTION: When transferring product from extreme temperature environments,(e.g.
cold truck to warm humid ballroom) condensation may form on the internal electronics
of the product. To avoid causing a failure, allow product to fully acclimate to the
surrounding environment before connecting it to power.
• Do not mount the product on a flammable surface(linoleum, carpet, wood, paper,
carton, plastic, etc.).
• Do not use in a confined space. Always install the product in a location with adequate
ventilation, at least 20 inches (50 cm) from adjacent surfaces.
• Be sure that no ventilation slots on the product's housing are blocked.
3.5.3. Power and wiring
To Next Page
Loading...
