Evolights SPARK PRO - Page 37

EVOLIGHTS SPARK PRO
Instrukcja obsługi / User Manual
36
Display
Description
Adjustable
Range
Preparing
page
Heating Up
DMX Address 1
The selected DMX starting address is 1.
The machine is heating up.
1 - 512
Standby
page
Ready to Spark
DMX Address 1
The selected DMX starting address is 1.
Finished heating up, ready to work.
1 - 512
Operation
page
Spark ON
DMX Address 1
The selected DMX starting address is 1.
The machine is outputting spark.
1 – 512
The longest duration of single time of spark output is 30 seconds when
machine works properly. The machine will automatically stop after 30
seconds continuous output with LCD showing "Spark OFF".For longer output,
just turn on spark again via DMX controller.
Status
pages
Device Error E0
DMX Address 1
The selected DMX starting address is 1.
The machine is having error. Error code is
E0.
1 - 512
Refer to "General Troubleshooting"chapter to for a brief description of
each error code.
Time is Up E5
DMX Address 1
The selected DMX starting address is 1.
There's no remaining run-time for machine
to continue output when this page shows.
Swipe a new card to top up run-time.
1 - 512
Refer to "Identify & Activate Spark Seed"chapter to for more information.