Evolis Pebble 4 - Setting of parameters; Windows print driver installation

17
S
S
e
e
t
t
t
t
i
i
n
n
g
g
o
o
f
f
p
p
a
a
r
r
a
a
m
m
e
e
t
t
e
e
r
r
s
s
Defining the parameters of the printer and of its driver is a
highly important step and requires very special attention.
As a matter of fact, a poorly-defined film, or improper
settings, are factors that have a negative impact on the quality
of personalization.
It is therefore essential to proceed in stages, changing the
parameters only when you are completely sure.
Evolis gives you at all times the ability to return to the ‘factory’
settings if the adjustments made do not give the expected results.
Be careful about defining the personalized parameters and do not hesitate to contact your
Evolis dealer to get the necessary advice and assistance prior to any modification.
WWiinnddoowwss pprriinntt ddrriivveerr
The Evolis Pebble and Dualys drivers operate under Windows XP, 2003 and Vista 32 and 64-bits
IInnssttaallllaattiioonn ooff tthhee pprriinntt ddrriivveerr
To install your print driver, you will need the CD-Rom ‘Drivers and Documentation’ shipped with your
Evolis printer.
Please make sure the data cable is disconnected before starting this procedure.
The installation program automatically selects the version to be installed in terms of your
operating system.
1. Load the ‘DRIVERS & DOCUMENT
A
TIONS’ CD-Rom in y
our CD drive.
2. W
ait a f
e
w sec
onds until the welcome screen asks you to choose your language. If the
CD-Rom does not launch aut
omatic
all
y, double click on the setup.exe file located in the DRIVERS
directory on the CD-Rom
3. Sel
ect y
our language by clicking on the appr
opriate flag.
4. Click the “Ins
t
all Driv
er” option t
o launch the setup pr
ogr
am
2
2
2
2