PREPARATION
A solid, level base is required. It should be a minimum of 600mm x 600mm,
to allow easy access to your valves and for maintenance purposes.
Important: The EazyPod Complete filter needs to be supported evenly on a level
base (a paving flag is ideal). Failure to do so could cause damage when it is full of
water.
INSTALLATION EQUIPMENT
1. Pond Pump. Please ensure that the pump’s maximum actual flow rate is no more
than the specified limits (see page 6).
2. Air Pump for cleaning the K1 media. An EA Airpump 70 is recommended.
3. A length of garden hose or braided pipe (10 mm inner diameter) to connect your
air pump to the air ring in the EazyPod Complete.
4. Tip: When connecting to your air pump, cut an inch from the airline supplied
on the EazyPod Complete. Insert this into the hose pipe that connects to the air
pump. This will help maintain the hosepipe’s rigidity when inserting it into the
rubber connector and clip supplied with your air pump.
5. Pipe work from the unit’s waste valves to the intended discharge point. This can
be rigid pipe work or a simple flexible hose.
INSTALLATION
9
To Next Page
Loading...
