8
PLEASE NOTE: EazyPod Complete is designed to be used on a Pump Fed set-up
only. We do not recommend installing the EazyPod Complete on a Gravity Fed set-up.
The diagram below shows the EazyPod Complete on a typical Pump Fed set-up.
A Pump Fed set-up is when water is pumped from the pond to the filter.
INSTALLATION
POND
3” / 90mm or 4” / 110mm return
Slide Valve
UV Bulb
Power Lead
PUMP
PLEASE NOTE: The pump must not be placed on the base of the pond, as failure in
the pipe work or connectors could lead to complete drainage of the pond. The pump
should be raised at least 12” off the ground or high enough to leave sufficient water
for the fish to survive, in the unlikely event that this occurs.
To Next Page
Loading...
