21
www.evolutionpowertools.com
FR
ES
EN
(6.1)
Note: Any maintenance must be carried out with the
machine switched off and disconnected from the
mains/battery power supply.
Check that all safety features and guards are operating
correctly on a regular basis. Only use this machine if all
guards/safety features are fully operational.
All motor bearings in this machine are lubricated for life.
No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine’s. Do not use solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed
objects through openings in the machines casings etc. The
machines air vents should be cleaned using compressed dry air.
Excessive sparking may indicate the presence of dirt in the
motor or worn out carbon brushes.
(6.2)
If this is suspected have the machine serviced and the brushes
replaced by a qualified technician. (<6.2)
(>6.5)
ADJUSTING GIBS (Dovetail Gibs Slides) FREE PLAY
Before every use, lubricate and adjust as necessary. (Fig. 10)
Refer to ADDITIONAL SAFETY INSTRUCTIONS 3 for detailed
instructions on the adjustment of the Dovetail Slides. (<6.5)
(6.4)
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
FIG. 10
To Next Page
Loading...
Need help?
General
