19
www.evolutionpowertools.com
EN
IT
When a cut has been completed release the
ON/OFF trigger switch and allow the blade to
come to a complete halt. Do not apply lateral
pressure to the blade disc in an attempt to
slow it down more quickly.
WARNING: If the motor should stop or stall
whilst a cut is being attempted release the
trigger switch immediately and disconnect
the machine from the power supply. Remove
the machine from the workpiece before
investigating the cause and attempting to
restart the motor.
Note: This saw is fitted with an overload
protection device. This is designed to prevent
overloading and consequent damage to the
motor. If this feature ‘trips’, the motor stops
and will not operate.
Allow the machine to cool down and then press
the ‘reset switch’ at the base of the main handle.
MAINTENANCE
Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the power supply.
Check that all safety features and guards are
operating correctly on a regular basis. Only use
this machine if all guards/safety features are
fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication
is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings
in the machines casings etc. The machines air
vents should be cleaned using compressed
dry air.
Excessive sparking may indicate the presence of
dirt in the motor or worn out carbon brushes.
Brush Checking and Replacement
To replace the motor brushes:
• Disconnect the machine from the
power supply.
• Place the machine on a level, secure surface.
• Remove the (2) motor brush retainer
cap screws.
• Withdraw the brushes.
Note: If the Carbon rod is less than 6mm long
or if there are signs of burning or damage,
replace the brushes.
• Fit the new brushes.
• Refit the motor brush retainer caps.
• Run the saw without load for several
minutes after brush replacement to aid the
‘bedding in’ process.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice
To Next Page
Loading...
Need help?
General