17
www.evolutionpowertools.com
EN
IT
Operating Advice
Carry out routine safety checks each time you use the machine.
Check that all safety guards are operating correctly, and that all
adjustment handles/screws are tightened securely.
Check that the blade is secure and installed correctly. Also check
that it is the correct blade for the material being cut.
Check the integrity of the power cord.
Always clamp the workpiece to a rigid support such as a bench
or saw horse whenever possible.
ON/OFF Trigger Switch
This machine is equipped with a safety start trigger switch.
To start the machine:
• Push in the safety lock button on the side of the
handle with your thumb.
• Depress the main trigger switch to start the motor. (Fig. 8)
Chip Collector
This machine is fitted with a chip collector to capture metal
chips. The chip collector cover plate is provided with a
transparent ‘window’ so that the operator can see the contents
and empty when necessary.
To remove and empty the chip collector:
• Loosen the two chip collector thumb screws.
• Ease the chip collector from the machine.
• Empty the contents of the chip collector by tipping the
collector upside down over a suitable waste container,
allowing the contents to fall out.
Note: To maintain operational efficiency we recommend that
the collector is emptied when approximately 60% full. Dispose
of the contents of the chip collector in an environmentally
responsible manner.
• Replace the chip collector and securely tighten
the (2) thumb screws.
Fig. 8
To Next Page
Loading...
Need help?
General