Evolution RAGE7-S - Operation: Blade Installation and Removal; Operation: Controls; On;Off Trigger Switch

11
www.evolutionpowertools.com
EN
DE
OPERATION
1. INSTALLING OR REMOVING A BLADE (Fig. 1)
WARNING: The jigsaw must be disconnected from the power
supply and the blade must not be facing the operator when
installing or removing the blade.
Installation:
• Checkthatthejigsawbladeisofthecorrecttype.
• Insertthebladeintothechuckensuringthatthebladeteeth
face forwards.
• Rotatethechucklockingcollarforwardandslidethejigsaw
blade fully ‘home’ into the chuck. Ensure that the ‘T’ bar of the
bayonet tting is fully engaged within the chuck. (Fig. 1)
• Releasethechucklockingcollar.
• Checktoensurethebladeissecurelygrippedbythechuck.
• Checktoensurethatthebackofthebladehasengagedinto
the groove in the guide roller. (Fig. 2)
Removal:
Note: A recently used blade can be very hot. Allow such a blade
to cool down before attempting to remove it from the machine.
• Disconnectthemachinefromthepowersupply.
• SettheCuttingAction.SelectionSwitchtoposition0.
• Rotatethechucklockingcollarforwards.
The blade will automatically eject from the machine.
Note: The blade may eject from the chuck with some force.
Ensure that the ejecting blade will not strike any nearby surface,
bystander or animal. If possible eject a used blade directly into a
scrap recycling bin.
2. ON/OFF TRIGGER SWITCH (Fig. 3a)
This tool is tted with a variable speed Trigger Switch that
delivers higher speed as the trigger pressure is increased.
EXPLANATION OF Fig. 3a NUMBERS:
1 = TRIGGER SWITCH
2 = LOCKING BUTTON
3 = ROTARY CONTROL
The Trigger Switch is also tted with a rotary control (Fig 3b)
that allows the operator to select a constant speed and then
lock the trigger in this position.
Fig 1
Close up view of the quick
t/release chuck with the
blade inserted.
Fig 3 (a)
Close up view of Trigger
Switch, Locking Button
and Rotary Control.
1
2
3
Fig 2
Close up view of the
correctly tted blade with
the back of the blade
engaged into the groove in
the guide roller.