Speed Knob and Button Replacement
Speed Knob Replacement –
To replace the speed knob,
start by loosening the set
screw for the speed knob
using a small flat head
screwdriver. Install the
replacement knob and tighten
the new set screw.
Button Replacement – To replace the high/low beam, turn signal, forward/reverse, or horn button, start
by removing the headlight shroud. Once removed, locate the button you intend to replace, and separate
the electrical connector. Then, dismount the original button by depressing the push clamps on each side
of the button. A flat head screwdriver can help to depress the push tabs easier.
To Next Page
