4
> Maintain tools with care. Keep tools sharp and clean for
best and safest performance. Follow instructions for
lubricating and changing accessories.
> Disconnect the tool from the power source before servicing
or before changing accessories.
> Always turn off and unplug the lathe before adjusting the
belt to change the spindle speed.
> Always close and secure both the Side Belt Access Cover
and the Rear Belt Access Cover before turning on the lathe.
> Use recommended accessories. Consult the owner’s
manual for recommended accessories. The use of improper
accessories could create a risk of injury.
> Never stand on the tool. Serious injury could occur.
> Check damaged parts. Before further use of the tool, a
guard or other part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function – check for alignment of
SAVE THESE INSTRUCTIONS
moving parts, binding of moving parts, breakage of parts,
mounting and any other conditions that could affect its
operation. A guard or other part that is damaged should
be properly repaired or replaced.
> Direction of feed. Feed work into a blade or cutter against
the direction of rotation of the blade or cutter only.
> Never leave tool running unattended. Turn the power off.
Don’t leave the tool until it comes to a complete stop.
> Check your workpiece for any splits, cracks or other
defects that could compromise the integrity of the wood
and possibly lead to the workpiece coming apart or coming
off the lathe. Do NOT turn blanks that have defects.
> Always use the lowest speed (rpm) when starting
a new workpiece.
> Maximum length: 17
3
⁄4"
> Maximum diameter: 10"
PRODUCT SPECIFIC SAFETY WARNINGS CONTINUED
To Next Page
Loading...