Need help?Do you have a question about the Excelsior Rockler and is the answer not in the manual?
Follow all instructions, use tools, chemicals, and equipment safely.
Adhere to common shop safety rules, including keeping area clean and wearing PPE.
Warning about wood dust exposure causing cancer in California.
Ensure proper electrical grounding and safe cord handling to prevent shock.
Covers lifting, work area, attire, PPE, securing workpiece, and avoiding overreaching.
Maintain tools, disconnect power before servicing, close covers, use correct accessories, and check for damage.
Check workpiece for defects, use lowest speed for new workpieces, and observe maximum limits.
Lift safely with assistance and ensure the workbench is strong and stable.
Clean unpainted surfaces with a solvent-based cleaner and apply protective coating.
Connect to a properly grounded outlet, preferably GFCI, and avoid adapters.
Position lathe on a level, stable bench at elbow height with adequate maneuvering room.
Loosen covers and tension lever, move belt to desired pulleys, and secure covers.
Test run the lathe to ensure the selected speed is suitable for the workpiece.
Secure workpiece using Spur and Live Centers, ensuring proper alignment and tension.
Prepare blank, center faceplate, drill pilot holes, and secure faceplate with screws.
Vacuum debris, clean lathe bed, and check components for proper working condition.
Disconnect power, open access covers, loosen tension lever, and remove old belt.
Loosen set screw and rotate Headstock Wheel counterclockwise to remove.
Align pulleys, install new belt, adjust tension, and secure covers.
Illustrates the assembly of the Excelsior Mini Lathe with numbered parts.
Lists all parts for the Excelsior Mini Lathe with their corresponding quantities.
General| Brand | Excelsior |
|---|---|
| Model | Rockler |
| Category | Industrial Equipment |
| Language | English |
To Next Page