20
ADJUSTING THE BACKREST
The Rear Supporting Tube (15) can be adjusted between 3 different positions:
1. Users between the height of 5’1” and 5’3” may want to use position 1, as shown in FIG. A.
2. Users between the height of 5’4” to 5’11” may want to use position 2 as shown in FIG. B.
3. Users between the height of 6’ to 6’3” may want to use position 3 as shown in FIG. C.
Carefully disconnect the Connection Wires A (79) from the Hand Pulse Wires (98). Once a
position is selected, install two Carriage Bolts (106), two Flat Washers (33), and two Nylon Nuts
(34). Tighten the Nylon Nuts (34) using the 13-15mm Wrench provided. Then reconnect the
Connection Wires A (79) and Hand Pulse Wires (98).
To Next Page