What does it mean when the FIP status LED blinks red after capture on EXFO FIP-400B?
If the FIP status LED blinks red for 2 seconds when a capture is performed and no analysis results are available on your EXFO Analytical Instruments, there was an analysis error. Repeat the inspection process.
Why does the status LED blink magenta at startup on my EXFO FIP-400B Analytical Instruments?
If the status LED blinks magenta at startup on your EXFO Analytical Instruments, the probe is in standalone mode. Connect to the probe from ConnectorMax2 Mobile to return to standard mode.
General| Type | Fiber Inspection Probe |
|---|---|
| Light Source | LED |
| Image Sensor | CMOS |
| Magnification | 400x |
| Connector Types Supported | LC, SC, ST, FC |
| Connectivity | USB |
| Operating Temperature | 0 °C to 32 °F |
| Storage Temperature | -20 °C to -4 °F |
| Product Family | FIP-400B Series |
Provides a detailed description of the FIP-400B probe and its operational controls.
Details on the companion mobile application for fiber inspection and analysis.
Details safety precautions and equipment ratings related to electrical usage.
Steps to establish and terminate wireless probe connectivity with the mobile app.
Configuration of fields for identifying test parameters like cable ID and fiber ID.
Comprehensive guide for inspecting single fiber and transceiver connectors.
Explains how to perform and interpret automated pass/fail analyses.
Details the different types of fiber polarity in multifiber patchcords.
Provides guidelines for routine cleaning and upkeep of the unit.
Outlines essential safety precautions for handling and replacing batteries.
A table listing common issues and their corresponding solutions.
Information on how to send equipment for service or repair.
To Next Page
