Exmark Lazer Z HP - Setup Instructions Manual

Page 1 of 4
109-2027 Rev. A
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Part # Description Qty Use
323-6
98-5975
3290-357
Cap Screw, Hex 3/8-16 x 1
Washer, Belleville
Nut, Hex Flange 3/8-16
8
8
8
Installing the Rollover Protection System (Roll Bar)
103-1309 Warranty Registration Form 1 Fill out and return to Exmark
109-0936
109-0034
Literature Pack (Kawasaki)
Literature Pack (Kohler)
1 Contains unit specific material
103-2106 Keys 1 Unit ignition
106-7022 Tube, Oil Drain 1 Kawasaki only; Draining engine oil
109-0036
109-0035
103-9143
Manual, Operator’s
Manual, Parts
DVD, Exmark Safety Video
1
1
1
Read and view before operating machine
1-809066 Tie, Plastic (5/16” x 24”) 1 Kohler only; To secure Engine Oil Drain Hose to Roll Bar
1-850285
106-8294
Manual, Engine Operator’s
Manual, Engine Operator’s
1
1
For units with Kohler engines only
For units with Kawasaki engines only
32128-20 Nut, 5/16-18 Whizlock 4 To fasten seat tracks to unit seat frame
Installing the Rollover Protection
System (Roll Bar)
1. Remove sides and top of crate from the base.
2. Remove roll bar components from the crate.
3. Remove roll bar tubes from sides of crate.
4. Remove the two brackets used to mount the
bottom of the upper roll bar tube to the crate.
5. Remove the 1/2-13 x 3 1/4 capscrews and 1/2-13
hex flange lock nuts from the two brackets at
each end of the upper roll bar tube and retain for
later use (Fig. 1).
6. Remove the (4) 1/4” lag screws holding the
wheel hub brackets to the crate bottom and
discard.
7. Raise the rear of the unit approximately 10-12”
and support it with jack stands or equivalent
support.
CAUTION
POTENTIAL HAZARD
♦ Raising the rear of the unit for assembly relying
solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the unit to fall, which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands or
equivalent support.
8. Locate the left and right lower roll bar tubes.
9. Align lower roll bar tubes along rear engine frame
(Fig. 2).
LAZER Z
®
HP
SETUP INSTRUCTIONS
Figure 1
For Serial Nos. 600,000 and Highe
r