Exodraft MEC24 - Detailed Control Programming

To Next Page

To Previous Page

5.6 Detailed control programming

Menu 362: USB logging

The MEC24 can be set to log on a USB-momory stick if the menu 492 is set to “USB” If this is done, two les will be created:

one with the alarm log and one with the values of the XTP sensors and 0-10V. The les are .CSV les.

The output format is:

[Unix time], [Exhaust XTP 0-1024], [Intake XTP 0-1024], [Exhaust VFD 0-1024], [Intake VFD 0-1024], [Damper Out 0-1024],

[MODS XTP 0-1024]. The value between 0-1024 is a fraction of 10V, meaning that a value of 423 equals 4.13 V.

Menu 365: Firmware upgrade

The MEC24 can be rmware upgraded using a USB-memory stick. Insert the USB-memory stick with the rmware in the

USB connector on the front of the control. Go to the 362 menu, and select the correct le to be programmed. Press the

abutton to start the update. The update takes approx. two minutes.

Note! If the programming fails, power o the control. Press the x button and power up the control again. Doing this will

reupload the latest working rmware.

3120066 MEC24 US 20210325