3. Mechanical installation
3.1 Location
The control and the transducer can be installed indoors and outdoors. The control does not need to be installed in an
enclosure. Fig. 2 shows how the components are connected.
Fig. 2aFig. 2
MEC24 Con-
The transducer cannot be mounted inside an airtight enclosure. It uses the boiler room pressure/atmos-
pheric pressure as reference pressure.
3.2 Mounting of control
The control can be mounted directly on a wall or similar.
y Remove the clear cover.
y The mounting holes are located under the plastic screws that hold the cover in place (Fig. 3).
y The distance between the control and the transducer should not exceed three hundred (300) feet.
Fig. 3
6
3120066 MEC24 US 20210325
To Next Page
Loading...