Expobar Markus MINI - Buttons Functions; Programming

30
Markus
Buttons functions
PROGRAMMING
1 Short
espresso
1 Long
espresso
2 Long
espresso
PROGRAMMING MENU
CONTINUOUS BREWING
TEA (if it is activated)
2 Short espresso/
Auto-cleaning
The Continuous Dispensing button performs 3 different functions (depending on length of time pressed):
Machines equipped with display
Under 1 second: Enables automatic water- or steam-dosing (only on machines without manual taps).
Between 1 and 8 seconds: Enables Continuous Dispensing (press again to disable).
Over 8 seconds: Access coffee-dose programming menu (see below).
Machines not equipped with display
Under 4 seconds: Enables Continuous Dispensing (press again to disable).
Over 4 seconds: Access coffee-dose programming menu (see below).
The following functions can be programmed and controlled from the digital display:
Volume control of four different espresso drinks per brewing group.
Timed hot water dispensing.
Automatic boiler filling and level control.
Automatic heating element shut-down in event of a low water condition.
System supervision through messages, warning, and alarms.
Automatic cleaning of the brewing groups.
The digital controller is programmed with four standard drink functions (these can be reprogrammed
as desired by the user) and one continuous function from the manufacturer.
The upper four left-side buttons (1 Short Espresso, 1 Long Espresso, 2 Short Espressos, 2 Long
Espressos) will brew the programmed beverage volume and then stop automatically.
The fifth/right-side button (Continuous) brews continuously until the user stops it by pressing the
button again.