What to do if my Expobar MONROC does not start up?
If your Expobar Coffee Maker doesn't start, first ensure the plug is correctly inserted into a working power socket. Next, check that the circuit breaker and/or differential are connected. If the issue persists, the cable or plug may be damaged, and you should call service personnel to replace them.
Why is coffee dispensing so slow on my Expobar MONROC?
If the coffee dispensing from your Expobar Coffee Maker is very slow, it's likely that the coffee grinding is too fine. Adjust the coffee-grinding setting to a coarser level.
How to fix fast coffee dispensing on Expobar MONROC Coffee Maker?
If coffee dispensing from your Expobar Coffee Maker is happening too quickly, the coffee grinding is probably too coarse. You should adjust the coffee-grinding setting to a finer level.
How to fix fast coffee dispensing on my Expobar MONROC?
If coffee is dispensing too quickly from your Expobar Coffee Maker, it's likely that the coffee grinding is too coarse. Try adjusting the coffee-grinding setting to a finer grind.
How to fix an Expobar MONROC steam wand that does not dispense steam?
If the steam wand on your Expobar Coffee Maker isn't dispensing steam, it's likely clogged with milk. Clean the wand, and if necessary, remove the nozzle and carefully unclog it using a pin or needle.
What to do if there's water under my Expobar MONROC Coffee Maker?
If you find water underneath your Expobar Coffee Maker, it's likely that the drainage tube is blocked. You should clean the drainage tube to resolve this issue.
Why is the steam wand not working on my Expobar MONROC?
If the steam wand on your Expobar Coffee Maker isn't dispensing steam, it's probably clogged by milk. Clean the wand. If necessary, remove the nozzle and unclog it using a pin or needle.
What to do if I find water underneath my Expobar Coffee Maker?
If you find water underneath your Expobar Coffee Maker, the drainage tube is likely blocked. Clean the drainage tube to resolve this issue.
General| Type | Espresso Machine |
|---|---|
| Weight | 65 kg |
| Pump | Rotary |
| Material | Stainless steel |
| Pressure Gauge | Yes |
| PID Temperature Control | Yes |
| Pre-infusion | Yes |
| Number of Groups | 2 |
To Next Page
