EasyManuals Logo

Extech Instruments EX210 User Manual

Extech Instruments EX210
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
EX210_EX210T-en-US_v1.5 9/15
10
Maintenance
WARNING: To avoid electric shock, disconnect the test leads from any source of voltage before
removing the back cover or the battery or fuse covers.
WARNING: To avoid electric shock, do not operate the meter until the battery and fuse covers are
in place and fastened securely.
This MultiMeter is designed to provide years of dependable service, if the following care instructions
are followed:
1. KEEP THE METER DRY. If it gets wet, wipe it off.
2. USE AND STORE THE METER IN NORMAL TEMPERATURES. Temperature extremes can
shorten the life of the electronic parts and distort or melt plastic parts.
3. HANDLE THE METER GENTLY AND CAREFULLY. Dropping it can damage the electronic parts
or the case.
4. KEEP THE METER CLEAN. Wipe the case occasionally with a damp cloth. DO NOT use
chemicals, cleaning solvents, or detergents.
5. USE ONLY FRESH BATTERIES OF THE RECOMMENDED SIZE AND TYPE. Remove old or
weak batteries so they do not leak and damage the unit.
6. IF THE METER IS TO BE STORED FOR A LONG PERIOD OF TIME, the batteries should be
removed to prevent damage to the unit.
BATTERY and FUSE Replacement
WARNING: To avoid electric shock, disconnect the test leads from any source of voltage before
removing the battery cover.
1. Turn power off and disconnect the test leads from the meter.
2. Lift the meter stand to expose the battery cover.
3. Open the rear battery/fuse compartment by removing the Phillips head screw on the lower rear of
the meter.
4. Carefully pull down on the cover just enough to release the latch and then lift it off. The cover will
not pull down all the way.
5. Remove the old battery or fuse and install a new one of the correct rating.
6. Place the battery/fuse cover back in place. Secure with the screw.
WARNING: To avoid electric shock, do not operate the meter until the battery cover is in place and
fastened securely.
NOTE: If the meter does not work properly, check the fuses and replace the battery to make sure that
they are still good and that they are properly inserted.
Battery Safety Reminders
o Please dispose of batteries responsibly; observe local, state, and national regulations.
o Never dispose of batteries in a fire; batteries may explode or leak.
o Never mix battery types; install new batteries of the same type.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extech Instruments EX210 and is the answer not in the manual?

Extech Instruments EX210 Specifications

General IconGeneral
BrandExtech Instruments
ModelEX210
CategoryMultimeter
LanguageEnglish

Related product manuals