Extech Instruments RHT10 - Operation; System and Hardware Requirements; Software and Driver Installation

RHT10 HW_SW-en-US_V5.6.2 6/16
4
Operation
SystemSoftwareRequired:
Windows7,Windows8.1orWindows10
MinimumHardwareRequired:
PCorNotebookwithPentium90MHzorhigher32MBRAM;
Atleast7MBofharddiskspaceavailabletoinstallDataloggerUSBsoftware.
Recommendeddisplayresolution1024X768withHighColor(16bit).
INSTALLINGTHEGRAPHINGSOFTWAREandUSBdriver
InstallthesuppliedWindowsPCDataloggerSoftwarebyplacingthesuppliedprogramdiskinthe
PC’sCD‐ROMdriveorbydownloadingtheprogramfromthe
http://Extech.com/instruments/software.aspwebpage.

Iftheinstallationprogramdoesnotautomaticallyopenandprovideon‐screenprompts,openand
browse the CD‐ROM drive, then find and double‐click on the SETUP.EXE file included on the
programdisk.Followtheon‐screenpromptstocompletetheinstallation.
SoftwareInstall
RunSETUP.up.exeandfollowthedefaultstoinstallheRTH10software
USBDriverInstall
 1.OpentherootfolderoftheRHT10.
 2.OpenthefolderDriver\DriverUSBXPRESSanddouble‐clickonUSBXpressInstaller.exe.
 3.FollowthedefaultchoicestoloadthisUSBXpressdriver.

Note:WhentheRHT10isconnectedtotheUSBport,thebatteryinsidethedeviceisdischargedat
ahigherratethannormal.Toconservebatterylife,donotleavetheRHT10connectedtotheUSB
portforaprolongedperiodoftime
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com