10 SDL200-EN V2.3 07/13
Battery Replacement and Disposal
When the low battery icon appears on the LCD, the batteries must be replaced. Several hours of
accurate readings are still possible in this condition; however batteries should be replaced as soon
as possible:
Remove the two (2) Phillips screws from the rear of the meter (directly above the top of the tilt
stand).
Remove and safely place the battery compartment and screws where they will not be damaged
or lost.
Replace the six (6) 1.5V ‘AA’ batteries observing polarity.
Replace the battery compartment cover with the two (2) Phillips screws.
Battery Safety Reminders
Please dispose of batteries responsibly; always observe local, state, and federal regulations
with regard to battery disposal.
Never dispose of batteries in a fire. Batteries may explode or leak.
Never mix battery types. Always install new batteries of the same type.
To Next Page
Loading...
