When in doubt, we recommend that you always install a fresh battery before logging critical data.
If INSTANT was selected in the SETUP window, the TH10 begins logging at the instant the SETUP button is pressed. If
MANUAL was selected, the TH10 must be manually started by pressing the unit’s orange button once until the Record LED
(Green) flashes.
Logging will continue at the programmed sample rate until the number of readings (sample points) specified in the Setup
window is reached or the User terminates the logging session by clicking on the software’s download button.
The green LED flashes once per sample point and the yellow LED flashes when user programmed alarm limits are exceeded.
See LED status in the TH10 User’s manual.
Real-Time Setup
Click the Datalogger Setup icon or select Datalogger setup from the File pull-down menu.
Select the Real-Time tab. The setup menu will appear as shown below
§ SAMPLE RATE: This field instructs the TH10 to log readings at a specific interval rate.
§ MAX POINTS: This field instructs the TH10 to take a set number of readings.
§ TEMPERATURE UNIT: Selects the Temperature units of Celsius or Fahrenheit.
Once the changes have been made, click on the SETUP button to save them. Press the DEFAULT button to set the TH10
back to factory default conditions. Press the CANCEL button to abort the setup.