Extech Instruments TM500 - Page 5

5 TM500-EU-EN v1.1 12/13
SettingdataloggingLoopmode
Thismeter canbesettorecordtemperature sforthesametimeeveryday.
Example–reco rd temperatureseverydayfrom9:00to13:00
1. AccesstheLooPparameter
.
2. PresstheENTERbutton.
3. Se
ttheStartHour(0‐23)andpressENTER.
4. SettheStartMinuteandpr
essENTER.
5. SettheStopHourandpressENTER.
6. SettheStopMinuteandpr
essENTER.
7. PresstheupordownarrowtoindicateYES andpressENTER .
8. PresstheRECbuttonsotheRECiconisvisibleonthedisplay.The meterisnowsetupto
recordtemperatureeve ryda yforthesettimewindow.
SettingdECmode‐NumericalFormat(commaordecimal)
EuropeanandUSAnumericalformatsdiffer.ThemeterdefaultstoUSAmodewhereadecimal
pointisusedtoseparateunitsfromtenths,i.e.20.00;TheEuropeanformatusesacomma,i.e.
20,00toseparateunitsfromtenths.Tochangethissetting:
1. AccessthedECparameter.
2. UsethearrowbuttonstoselectUSAorEUro.PressENTERtoconfirmsetting.
3. PresstheENTERbutton toexi
ttotheSetupmode.PressESCtoexitsetupmode.
SettingPoff‐Enabling/DisablingtheAutoPowerOFFFeature
1. AccessthePoFFparameter.
2. UsethearrowbuttonstoselectON(enable)orOFF(disable).WiththeAutoPowerOFF
featureenabled,themeterwillautomaticallyswitchOFFafter10minutesofinactivity.
3. PressENTERtoconfirmsetting.
4. PresstheENTERbutton toexittotheSetupmod
e.PressESCtoexi
tsetupmode.
SettheBeeperSoundONorOFF
1. AccessthebEEPparameter.
2. UsethearrowbuttonstoselectONorOFF.PressENTERtoconfirmsetting.
3. PresstheENTERbutton toexittotheSetupmode.PressESCtoexitsetupmode.
netzerotools.com
netzerotools.com