Extel WAVE - Monitor User Manual and Functions; Monitor Button Functions; Main Menu Navigation

EXTEL - WAVE - 720313
en - 5
6 - PAIRING THE MONITOR WITH THE POWERBOX
To simplify product installation, the screen and the PowerBox of your kit have already been paired at the factory.
If pairing has not been successfully completed during the production stage, you can do it by following the steps
below
Note: For example, you can place the 2 products close by on a table or any other flat base. You may get a
feedback effect if the intercom panel and the monitor are too close (screeching noise).
1 - Put the screen in pairing mode
In the menu of your videophone, go to the settings sub-menu
In the settings sub-menu, select the second line and launch the pairing mode
E - INSTALLATION