Extra 200 - Page 168

CHAPTER 27
PAGE 21
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
10 Slip 600 mm teflon protective hose on the control cable
end. The protective hose should extend to the first
fairlead inside the fuselage.
11 Adjust rear pedals in middle position.
12 Fix rear pedals in vertical position (90° relative to the
footrest).
13 Pre-install the LN9355-06-20 bolt, the DIN 125 M6
washers (2 washers outside, 3 washers inside), the
spring clip, the LN 9348 M6 stop nut and the thimble
to the bottom hinge bellcrank (also see item 9 on Fig. 3
of Chapter 32).
14 Slip the 771095 shrinking sleeve and a NICOPRESS
18-3-M sleeve on the cable end.
15 Move the cable around the thimble and stretch the
control cable with a force that is equivalent to the trac-
tive effort of the rear pedal retracting spring.
I M P O R T A N T Clamping has to be performed in accordance with the
Service Bulletin 300-1-93 and the Instruction No. 32 of
the National Telephone Supply Co., Cleveland Ohio.
16 Consider to let a distance of 1 mm between the thim-
ble and the sleeve and clamp the sleeve.
17 Cut the free end of the cable 20 mm in front of the
sleeve.
18 Slip the shrinking sleeve on the cable end and heat up
with a heat gun.
19 Remove the pedal securing device.
20 Mount the pre-assembled shackle of the shorter con-
trol cable to the front pedal.
21 Thread the free end of the control cable through the
pulley, the front fairleads and the pre-installed NICO-
PRESS 18-3-M sleeves.
22 Fix the front pedal in vertical position (parallel to the
firewall).
23 Stretch the shorter control cable with a force that is
equivalent to the tractive effort of the front pedal re-
tracting spring.
MAINTENANCE PRACTICES
Control Cable Installation