ExtractCraft Source Turbo - Strain and Prepare the Source; Place the Lid

The Source User Manual Source Operation & Making A Plant Extract
 
4
5. STRAIN THE TINCTURE
Strain the tincture into the reservoir
cup. Use a strainer, coee lter, or
Buchner funnel to remove particles.
Tip The repeated and thorough filtering
results in a more clear end product.
6. READY THE SOURCE
Place the Source on a at surface.
Check that the lower seal is aligned
with the base. Ensure the outer
collector is seated properly in the
recess of the lower seal on the base. A
vacuum will be formed in the collector,
so it must make good contact with the
lower seal.
7. INSTALL THE RESERVOIR CUP
Carefully reach inside the collector
and gently screw the reservoir cup
onto the threaded post.
Lightly screw by hand
only. Do not 'tighten'.
8. PLACE THE LID
Place the lid flat with the wide rubber
seal facing down and in contact with
the glass collector rim.
Once the Source is in operation, a
vacuum is created and the lid will be
held firmly in place with negative
pressure.
Screw the
reservoir
cup onto the
threaded
post of the
base lightly.
Place the
lid on the
collector.
Ready the
Source.
Strain the
tincture into
the reservoir
cup.
reservoir cup
Tip The wider rubber ring
of the upper seal rests on
the rim of the collector. The
narrower rubber ring faces up.