picture and secure with a small piece of strapping tape. Slide the rudder into
position and glue the hinges in place with thin CA.
11. Locate the elevator control horn and glue in place with medium CA or epoxy.
Use a #11 blade to remove the covering from the elevator servo slot and install
the servo using the manufacturer supplied mounting hardware. Place an ez-
connector on the servo arm. Locate the elevator pushrod and insert the z-bend
into the phenolic control horn and the other end into the ez connector.
Electronically center the servo and then tighten the screw in the ez connector to
clamp down on the pushrod, while making sure the elevator is in the neutral
position. You may need to put a small bend in the pushrod. Pictured is the Hitec
HS-55 sub-micro servo, however we strongly recommend using a stronger servo
if you intend to set-up the Extra for 3D flying. We have had great success with
the Hitec HS-56 and the JR 281.
10
To Next Page
Loading...
