www.modellmarkt24.ch
12
17. Attach an 18" Extreme Flight 28AWG servo extension to the elevator servo lead and secure with heat
shrink tubing or an Extreme Flight servo extension lock. Install the elevator servo into its slot and
assemble the linkage as shown. There is a G10 servo arm included in the hardware package, used to
achieve 3D throws in excess of 50 degrees. Attach this arm to the stock servo arm with a 2mm screw and
nut as shown. Use your power drill to help thread the ball links onto the pushrod.
www.modellmarkt24.ch
To Next Page