www.modellmarkt24.ch
4
Items needed for completion
-masking tape
-Thin and medium CA. We highly recommend Mercury M5T thin and M100XF medium
formulas as well as the Mercury glue tips.
-Blue Loctite.
-Electric drill with an assortment of small drill bits.
-Small flat head and Phillips head screw drivers.
-Standard and needle nose pliers.
-Metric balldriver or allen key set.
-4 sub micro metal geared servos. All flight testing was performed with Hitec HS-70MG
-Torque 2814T/820 Brushless Outrunner motor.
-Airboss Elite 45 Amp ESC.
-4S 2100-2700 mah LiPo battery.
-Falcon or APC 12x6 E prop (NOT the slow fly version!).
-52mm Extreme Flight spinner.
-2 18" extensions for the 2 rear servos and 2 6" extensions to go between the receiver and
the aileron servo leads. We recommend the Extreme Flight 28 AWG servo extensions to
save weight.
-Adhesive backed Velcro and Velcro strap for battery retention.
Please note: The Extreme Flight 4 in 1 airplane stand is invaluable when assembling our
aircraft, from the 48" size models right up to our 50cc models. I can't imagine assembling
all of the aircraft I do without the aid of this inexpensive yet handy tool!
https://extremeflightrc.com/4-in-1-Airplane-Stand_p_1892.html
www.modellmarkt24.ch
To Next Page
Loading...
