www.modellmarkt24.ch
5
1. Gather the components for the landing gear assembly.
2. Insert the threaded portion of the axle into the carbon fiber landing gear. Slide a
washer onto the axle followed by a nylon insert lock nut. Do not tighten yet.
3. Slide a wheel onto one of the axles and secure with a wheel collar. For best results file a
small flat spot on the axle for the wheel collar's set screw to seat against. Repeat the
process for the other wheel. Be sure to place a drop of blue thread lock on the setscrew.
www.modellmarkt24.ch
To Next Page
Loading...
