8.
Attach the cowl to the fuselage with screws and rubber washers as shown. Adjust and tighten the
prop mount and make sure you have a small amount of clearance (approx 2mm) between the
spinner backplate and cowl. NOTE: if you are new to high performance aerobatic aircra, your
motor points 2.5 degrees to the RIGHT to balance torque and prop forces. is is by design and is
correct.
NOTE: For safety, never connect your ight battery on your workbench with the prop installed.
Take the time to remove the prop when connecting the battery for setup work.
To Next Page
Loading...
