9.
Install your receiver in the position shown. If using the T-Motor power system, install the
power capacitor into any open channel of your receiver as shown. We prefer to use dou-
ble-sided foam tape and a zip-tie to mount our receivers. Install your lipo battery and two
strong velcro straps as shown.
Install your prop and spinner. Check the Center-of-Gravity of your plane and move the bat-
tery to achieve the location you want. Our favorite CG position is marked inside the fuselage.
is is very slightly behind the fuselage former. You can quickly check by liing the aircra
by the former. If it hangs close to level, you’re ne for your maiden ight.
To Next Page
Loading...
