10.
We prefer to use a cell phone with an angle-nder app as a control throw guage, but
any accurate gauge is ne. Set your control throws as recommended below. We have
recommended high expo for your maiden ight; if you have a favorite expo value
you typically run on 3D aircra, use it. Otherwise set it to the recommended expo
and reduce as desired.
Elevator: Low Rate 8-10 deg. 15-20% expo
3D Rate 45-50 deg. 60-65% expo
XA/Tumbling rate 55 deg. 65-70% expo
Aileron: Low Rate 15-20 deg. 40-45% expo
High Rate 38-40 deg. 70-75% expo
Rudder: Low Rate 20 deg 40-45% expo
High Rate 45-50 deg. 80-90% expo