2.
Installing main landing gear: Attach the carbon landing gear to the fuselage with screws as shown, use blue
Loctite (or other medium-strength threadlocker) on these screws. Note that there is a “front” to the landing
gear and when installed, they sweep slightly forward. Install the decorative cover plate as shown using Go-
rilla Clear Bond, GOOP, or other rubberized adhesive. Locate the fairings, test t them, and then prema-
nently attach them to the landing gear (not the fuselage) using a generous amount of rubberized adhesive.
Allow to dry. Locate the axles, attach to the landing gear as shown with washer and locking nut. Note there
is a at spot on the axle to engage the wheel collar set screw. Install the wheel and wheel collar, use loctite
on the collar set screw. Install the wheel pant with screw and loctite as shown.
To Next Page
Loading...
