3.
Installing the horizontal stab and elevators: Remove the tail ller piece as shown. Test t the stabilizer
without glue. Make sure it fully inserts into the fuselage as shown. Make sure you have it right-side-up.
When you have the stabilizer perfectly tted, glue it in place with thin CA glue, using the servo open-
ing and rear opening for access. apply 10-12 large drops of thin CA to permanently. Clean up any
spilled CA with acetone. NOTE: IF you wish to use epoxy glue to attach your stab, this also works well.
Apply the epoxy in a thing layer on the joint before inserting permanently in the slot. Use denatured
alcohol to clean up any excess expoxy.
Locate the tail ller piece. Fit it as shown. When it is perfectly aligned, apply thin CA glue as shown.
Clean up any spilled CA with acetone.
To Next Page
Loading...
