8.
Attach the cowl to the fuselage with screws, use loctite. Here we have added optional Extreme
Flight decorative aluminum washers. Adjust and tighten the prop mount and make sure you have
a small amount of clearance (approx 2mm) between the spinner backplate and cowl. NOTE: if you
are new to high performance aerobatic aircra, your motor points 2.5 degrees to the RIGHT to
balance torque and prop forces. is is by design and is correct.
NOTE: For safety, never connect your ight battery on your workbench with the prop installed.
Take the time to remove the prop when connecting the battery for setup work.
www.modellmarkt24.ch
To Next Page
Loading...
