1.
Installing control horns: All of the control horns on your aircra install in the same way. Locate the
correct control horn for each surface. Prep the horns by lightly scung the gluing area (the part which
will go into the control surface) with sandpaper or an emery board. Test t the horn and cover plate
without glue to make sure it goes all the way into the surface as shown. To permanently install the horn,
place medium CA glue into the slot, insert the horn fully and rmly into the slot, and then add a few
drops of thin CA for extra insurance as shown. Clean up any spilled CA with acetone. Allow to dry.
www.modellmarkt24.ch
To Next Page
Loading...
