Basic Access Point Configuration
AP-7532 Access Point Installation Guide 25
distribution. Its recommended you do not use VLAN 1 with the WLAN if the WAN
port has been enabled.
• Description - Optionally enter a WLAN description to further describe the WLAN’s
deployment objective.
18 Select Apply to commit the updates to the Access Point’s WLAN configuration.
19 Expand the Configuration menu item and select Services.
20 Select Enable DHCP Server to ensure the Access Point can provision IP addresses to
requesting clients over the specified interface.
21 Select + Add and provide a starting and ending IP range of addresses that constitute a
pool of addresses available to requesting clients.
22 Select Apply to commit the updates to the Access Point’s DHCP configuration.
23 At this point, you’re ready to connect to the network using the security restrictions
applied to the newly created WLAN. Ensure the new secure WLAN has been enabled,
and check whether a client is able to access the network.
NOTE
A VLAN must be already configured and available to the DHCP server as a viable
interface between the Access Point and requesting client. Refer to the LAN IP
Interface Settings field (within the Edit Access Point screen), and add a VLAN.
To Next Page
Loading...