3AP-7532 Access Point Installation Guide
1
Introduction
The AP-7532 external antenna and internal antenna Access Point’s are mid-tier Access
Point’s with a relatively small footprint which supports functionality for dependable and
efficient network performance.The AP-7532 is a 3x3:3 802.11ac Access Point utilizing one 2.4
GHz 802.11n radio and one 5 GHz 802.11ac radio. The Access Point housing is Plenum-rated
(UL2043).
The Access Point’s unique WiNG 5 software enables the Access Point to function as either a
Standalone Access Point, an Adaptive Access Point, or a Virtual Controller.
If new to Access Point technology, refer to the WiNG Access Point System Reference Guide
to familiarize yourself with Access Point technology and the feature set supported by the
WiNG operating system. The guide is available at www.extremenetworks.com/support.
This document is written for the qualified network device installer.
Document Conventions
The following graphical alerts are used in this document to indicate notable situations.
Warnings
• Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the AP-7532 Access Point.
• Remove jewelry and watches before installing this equipment.
• Verify any device connected to this unit is properly wired and grounded.
• Verify there is adequate ventilation around the device, and that ambient temperatures
meet equipment operation specifications.
NOTE
Tips, hints, or special requirements that you should take note of.
CAUTION
Care is required. Disregarding a caution can result in data loss or equipment
malfunction.
WARNING
Indicates a condition or procedure that could result in personal injury or
equipment damage.
To Next Page
Loading...
Need help?
General
